Easypix microscope Betriebsanleitung PDF herunterladen (Seite 64)

THE SIGNAL MODULES

The sum of the modulation inputs and the output value (for example of X-

Axis) should not exceed the -10V - +10V range. The Excitation signal

should not exceed the -5V - +5V range.

In addition, -15V and +15V voltage sources are available for driving small

home-made electronics. The voltages are available on the same type of

three-pole mini-DIN connector that is used in the Signal Module: S. The

pin-out of this connector is shown in figure Voltage source connector.

Using the User Inputs and Outputs

The user Inputs and Outputs can be configured using the User Input/Out-

put section of the Operating mode panel. This Section is only available in

the Advanced Level User Interface.

User 1 Input An analog input that can be used to record the signal from

external instruments in Imaging and Spectroscopy meas-

urements.

User 2 Input An analog input that can be used to record the signal from

external instruments in Imaging and Spectroscopy meas-

urements.

Aux 1 A connector that can be used for accessing signals that are

not otherwise available. Contact your local distributor if

you need to use this connector.

Aux 2 A connector that can be used for accessing signals that are

not otherwise available. Contact your local distributor if

you need to use this connector.

Signal name Function

Signal Module: A Signals

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 72 73

Keine Kommentare

Easypix microscope Betriebsanleitung Seite 64