Easypix microscope Betriebsanleitung PDF herunterladen (Seite 47)

FINISHING

For an in depth introduction to the Nanosurf Report software, refer to the

Introduction section of the Nanosurf Report online help.

Finishing

Once you are done measuring:

- Click to stop measuring.

- Open the positioning window.

- Click .

- Retract the cantilever to a safe distance from the sample by clicking

until the tip-sample distance is at least as large as shown in

figure View of the cantilever after manual approach (p.41).

Turning off the instrument

- Verify that you have saved all measurements that you would like to keep.

- Exit the easyScan 2 software after having stored all desired measurement

documents. If you exit the program whilst having some unsaved measure-

ments, you will be asked to save them now.

- Turn off the power switch.

- Store the Scan head in the Scan head case.

Important!

• Always store the scan head with an (old) cantilever installed. This will

prevent dust from gathering on the alignment chip, and protect the align-

ment chip against damage.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 72 73

Keine Kommentare

Easypix microscope Betriebsanleitung Seite 47